This is an original planning guide. It is not a vendor manual, an official standard, or legal advice. Example addresses use documentation ranges. Review every command before you paste it.
What this hour is for
The builder drafts a PowerShell command. It does not connect to a Hyper-V host. A remove or a delete is not in the draft. One guest.
The switch and the path are names you already have. Do not expose the management interface to the internet to try the command. Do not run it during the reading.
192.0.2.10/24 and example.com are documentation. They stay in the note.
The change you can finish
Apply nothing while you are writing the note. When the lab window opens, it is one change on the host named in the ticket. Read the draft, then the host, then decide.
Rollback is the file, the package version, or the snapshot you saved first. You do not invent a rollback after the only copy is gone.
- Name the host and the guest.
- Confirm you administer them.
- Draft a read or a lab create.
- Reject a delete.
- Do not run it during the reading.
- Stop.
Mistakes that outlive the command
Hyper-V PowerShell Guide goes wrong in a small set of ways. The list is here so the ticket can forbid them before the window.
- A delete in the draft.
- A host you do not administer.
- Management published to the internet.
- The command run during the reading.
- The wrong switch.
Decisions to write down
One decision for Hyper-V PowerShell Guide: The host is yours. No delete is in the draft. Management stays on the admin prefix. Nothing was run. And one guest.
Checks before you call it done
Confirm this before you call the change done: The host is written. The guest is written. No delete is present. Nothing was run. And the switch is a name you already use. If one of those fails, stop.
# No Remove-VM.
# A host you administer.
# Do not publish management.
# Do not run during the reading.Before you leave the host
Hyper-V PowerShell Guide ends when the hostname in the prompt matches the hostname in the ticket. If it does not, you are on the wrong host. Stop. A command that succeeded on the wrong host is not progress.
The draft stays a draft until a person has read the names in it. A generator does not log into the host and does not know which disk is empty. You delete a line that names a host, a path, or an account you did not write down.
192.0.2.10/24, gateway 192.0.2.1, 198.51.100.0/24, 203.0.113.0/24, and 2001:db8::/32 are documentation. example.com is a documentation name. They belong in the note. They are not values you leave on a host because a draft included them.
prompt-for-this is a reminder that a secret is missing. It is not a password, a key, or a token you save in the ticket or in git. The real secret stays in the password store.
One change is the window. If two things move and the result is wrong, you will not know which one did it. The next change waits for its own page.
If the same step fails twice, stop for the day. The failure is the result. Adding a forum command beside a half-applied change produces a host nobody can rebuild. Restore the copy you took first.
A second person reads the hostname and the change aloud. If they cannot find them in the ticket, the note is not done. Silence is not agreement. Then leave the host alone.
This page is a planning guide. It is not a vendor manual, not an official standard, and not permission to touch a host you do not administer. You do not disable a firewall, AppArmor, or SELinux to make a check pass.
Tools for this guide
These tools run in the browser on this site. They do not log into your machines.
Related pillar guides
More in this cluster
The pillar for this page, and the next published pages filed with it.